- Download the following three files.
- Unzip the installer and run the setup program.
- When that’s done unzip the updater and run it.
- When that’s done unzip the “BEST_BRAIN_2009_10″ archive and open the “default workspace” and that should
open it in IAR Workshop.
- Go to View->Messages->Tool Output.
- Press F7 to Build and then go to Tools->Boot Load Via USB to load it onto the robot (make sure the USB plug is plugged in and the robot is turned on).
- On the Output tab on the bottom you should see something after about 30 sec. that says the programming is complete.
- Shut the robot down for 10 seconds and then restart and it should work. Hope it works!
IARWorkbenchInstaller
IARWorkbenchUpdater
BEST_BRAIN_2009_10
If I wasn’t so lost I would have never been so found.